Masimo Radical Signal Extraction Betreibershandbuch PDF herunterladen (Seite 72)

Rad-8 Signal Extraction Pulse Oximeter Operator’s Manual 9-3

service / maintenance

Performance verification continued

LED BRIGHTNESS:

1. With the monitor turned on, press the Brightness Button once to enter the LED

Brightness menu. The display will show the default setting Level 2.

2. Continue pressing the Brightness Button to scroll through the settings.

3. Press the Enter Button to accept the desired setting. Let the device time out for 10

seconds to exit to the home display screen.

TESTING THE RAD-8 WITH MASIMO SET TESTER (OPTIONAL):

1. Turn the Rad-8 off and then on again.

2. Connect the Masimo SET Tester to the Pulse Oximeter Patient Cable Connector.

3. Verify that within 20 seconds

all available pulse bars display.

4. Verify that the SpO

measurement is between 79% and 84%.

5. Verify that the pulse rate measurement is between 55 bpm and 65 bpm.

6. Set the SpO

low alarm limit to 90 (see Section 4, Setup Menu Level 1, Parameter/

Measurement Alarm Limits and Setup Menu Level 2, Alarm Volume).

7. Verify that an audible alarm activates, the SpO

measurement and the SpO

parameter

label are flashing, and the Alarm Bell.

8. Press the Alarm Silence Button once and verify that the alarm is silenced and the

Alarm Bell

is flashing red.

9. Wait 120 seconds and verify that the alarm silence times out, the audible alarm is

activated again and the Alarm Bell.

10. Press the up arrow button several times and verify that the loudness of the pulse

beep tone increases.

11. Press the down arrow button and verify that the loudness of the pulse beep tone

decreases until the pulse beep tone is turned off.

12. Reset the device to original settings and remove the tester to complete the procedure.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78 79

Keine Kommentare

Masimo Radical Signal Extraction Betreibershandbuch Seite 72